Psion OMNII Manual do Utilizador descarregar pdf (Página 170)

Chapter 5: Configuration

Translations Tab

154 Psion Teklogix Omnii XT10 Hand-Held Computer User Manual

Good Scan Vibrates and Bad Scan Vibrates

These parameters determine whether or not Omnii creates a vibration when a good (success-

ful) scan or a bad (unsuccessful) scan is performed. Set these parameters to either on to

enable the beeper or off to disable it. You can set the Number and Duration of vibrations, as

well as the Pause between vibrations. The screen above shows the default settings.

Soft Scan Timeout

This parameter is used by the SDK “Scan” function (soft-scan: starting a scan session via the

SDK function, instead of a physical user trigger press). The value assigned to this parameter

determines the soft-scan timeout from 1 to 10 sec (default is 3 sec).

Scan Log File

If this parameter is enabled, the input bar code and the modified/translated output bar code

are logged in the file \Flash Disk\ScanLog.txt. Keep in mind that if Scan Log File is enabled,

there is a slight performance reduction when performing multiple scans since the log file is

written to persistent storage.

5.12.3 Translations Tab

The Translations menu allows you to define up to 10 cases, each consisting of up to 10 rules

in sequential order. Only one case will be applied to a bar code and a case will only be

applied if all rules specified in the case are successful—if a rule within a case fails, the entire

case fails.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 357 358

Sem comentários

Psion OMNII Manual do Utilizador Página 170