Psion OMNII Manual do Utilizador descarregar pdf (Página 166)

Chapter 5: Configuration

Bar Codes Tab

150 Psion Teklogix Omnii XT10 Hand-Held Computer User Manual

5.12.1 Bar Codes Tab

5.12.1.1 Scanner

The drop-down menu to the right of the Scanner option allows you to choose configurations

for one of the following scanner types, depending on what is installed in/on your hand-held:

Decoded (internal), Decoded (Intermec ISCP), Imager and Non-decoded.

The symbologies listed in the Barcodes tab change to reflect the scanner you choose and the

bar codes it supports. Always defer to your bar code scanner’s programming manual when

in doubt about the availability or settings for any parameter.

Keep in mind that some bar code types are only available when an internal imaging scanner

is installed. All internal scanners can be configured using these dialog boxes.

5.12.1.2 Restoring Default Settings

If you want to restore the factory defaults after making changes, the defaults can be applied

to a selected parameter, sub-tree of parameters or all scanner parameters.

Note: Your Omnii comes preconfigured from the factory for internal scanner types. The

type of scanner installed can be determined from the System icon in the Control

Panel, under the System Properties tab.

Important: To improve the decode speed and performance, enable (set to ‘on’) only

those codes that are required by the application.

For information on configuring the bar code symbologies, see Appendix C:

“Bar Code Settings”.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 357 358

Sem comentários

Psion OMNII Manual do Utilizador Página 166