Psion OMNII Manual do Utilizador descarregar pdf (Página 123)

Chapter 5: Configuration

Manage Triggers

Psion Teklogix Omnii XT10 Hand-Held Computer User Manual 107

Add Key

Only existing trigger sources are shown in the Source combo-box. To add a new source to

this list, tap on the Add Key button. A dialog will pop up and allow you to select the key-

board key to use as a trigger source.

Trigger-Press Type

You can enable either an Up/Down or Double Click response to a trigger press. Normally,

when a trigger (keyboard key, etc.) is pressed and released, a “trigger down” event is sent to

the “owner”—that is, the application receiving the trigger press information—followed by a

“trigger up”. If Double Click is chosen in this menu, when the trigger is pressed, released,

and then pressed again, a “double-click” event will have occurred. If a mapping with the

type Up/Down has also been configured for the same source, it will only receive the first set

of trigger events.

Module Trigger

This identifies the driver or application receiving the trigger presses.

Note: It is possible to map the same source to different modules (trigger consumers)—for

example, to both the Imager and Non-Decoded Scanner. If so, both devices/opera-

tions will occur simultaneously. This is not recommended in most cases, especially

with devices such as Imagers or RFID Readers.

It is also possible to map different sources to the same module (trigger con-

sumer)—for example, two different trigger keys can be mapped to the RFID

File System.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 357 358

Sem comentários

Psion OMNII Manual do Utilizador Página 123