Psion EP10 Manual do Utilizador Página 202

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 201
Chapter 7: Peripheral Devices & Accessories
Cleaning the RV4004
Psion EP10 Hand-Held Computer User Manual
188
7.6.4 Cleaning the RV4004
Use only mild detergent or soapy water on a slightly damp cloth to clean the RV4004. Avoid abrasive
cleaners, solvents or strong chemicals for cleaning. The plastic case is susceptible to harsh chemicals.
The plastic is partially soluble in oils, mineral spirits and gasoline. The plastic slowly decomposes in
strong alkaline solutions.
To clean ink marks from the label, use isopropyl alcohol.
7.6.5 Troubleshooting
7.6.5.1 EP10 Charge Indicator LED Stays Off
When an EP10 is docked into a powered RV4004 and the hand-held charge indicator LED stays off, there
may be a problem with the EP10 or with the docking station. Use an EP10 with a properly functioning
charge indicator to isolate the problem.
7.6.5.2 Power LED Does Not Light Up
Remove all the EP10s, and unplug the docking station.
Connect another device to the mains outlet to ensure there is power.
Remove the IEC mains power cable from the charger, and check it for damage.
Reconnect the mains cable in the charger and mains outlet.
7.6.5.3 EP10 Charge LED Flashes Yellow
A flashing yellow EP10 charge LED (the left-most LED on the hand-held) indicates that the battery is not
within the allowable charging temperature range — 0° C and 40° C (32° F to 104° F). Allow the battery to
come to an acceptable range before reinserting the EP10 in the docking station.
7.6.5.4 EP10 Charge Indicator LED Flashes Red
If the EP10 charge indicator flashes red when the EP10 is in any of the four sites, the quad dock cannot read
the battery or it is a non-Psion battery.
Remove the EP10s and disconnect the adaptor DC power cable.
Wait at least 20 seconds, and then plug the cable in again.
If the EP10 indicator still shows a fault, the EP10 requires service.
7.6.5.5 Powered Adaptor LED Stays Off
Check the AC cable. Replace with the same type if the cable is suspect.
If the adaptor LED stays OFF, the adaptor is defective and requires service.
7.7 Quad Charger – Model No. RV3004
7.7.1 C h a r g i n g t h e E P 1 0 B a tte r y
Quad Battery Charger (Model No. RV3004) can charge up to four batteries simultaneously.
7.7. 2 I n sta ll a t io n
The charger can be wall mounted using the wall mount bracket (model number RV6009) or it can be oper-
ated on a flat surface. Install the charger in an area that is free from excessive dirt, dust and contaminants.
The ambient temperature must be in the range 0° C and 40° C (32° F to 104° F). The charger will not
charge batteries outside of this temperature range. For maximum performance, it is recommended that the
charger be operated at room temperature – a temperature range between 18°C to 25°C (64°F to 77°F).
Important: Do not immerse the unit in water. Dampen a soft cloth with mild detergent to wipe
the unit clean.
Vista de página 201
1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 265 266

Comentários a estes Manuais

Sem comentários