
Chapter 7: Peripheral Devices & Accessories
Quad Dock Operation
187
Psion EP10 Hand-Held Computer User Manual
7.6 . 3.2 I nst al la ti on
The charger can be wall mounted using the wall mount bracket (model number RV6007) or it can be oper-
ated on a flat surface. Install the charger in an area that is free from excessive dirt, dust and contaminants.
The ambient temperature must be in the range 0° C and 40° C (32° F to 104° F). The docking station will
not charge batteries outside of this temperature range. For maximum performance, it is recommended that
the charger be operated at room temperature – a temperature range between 18°C to 25°C (64° F to 77° F).
7.6.3.3 Connecting to the Ethernet Network
Figure 7.5 RV4004 Quad Docking Station Rear View
Network Access
The EP10 automatically detects insertion into the docking station and loads the appropriate drivers to com-
municate with the network.
Network Addressing
The host application uses standard TCP/IP protocol to name, locate and communicate with a specific EP10
on the network.
If a link is established between an EP10 and a host, the application on the host and on the EP10 must have a
recovery mechanism in the event that the EP10 is removed from the dock, interrupting the link.
Note: Battery charging continues whether the EP10 is switched on or off.
Important: Use IEC-320 C13 power cords approved by Psion, with the ground pin connected
to a proper earth-grounded receptacle. Check with a qualified electrician if you are
uncertain of your receptacle grounding.
Important: If you choose to wall mount the charger, detailed installation instructions are
included in the ‘EP10 RV4004 Charger Quad Dock Quick Start Guide’
(PN 8000232) included with the quad docking station. Be sure to locate the
charger in an area where there is no risk of injury to persons walking in
the vicinity.
Power LED
Ethernet socket
DC socket
Comentários a estes Manuais